DSS7805
ADDITIONAL HANDSET
OWNER'S MANUAL
OWNER'S MANUAL
Installing Your Expansion Handset
Follow these three easy steps to get your new handset ready to use:
1
2
3
Install the battery pack.
Connect the charger and charge your new handset for 15-20 hours.
Register your new handset to the main base unit.
Step 1: Install the Battery Pack
1
Press down on the handset battery case cover
(use the finger indention for a better grip) and
slide the cover downward to remove.
Plug the battery pack connector (red & black
wires) into the jack inside the battery
compartment. (The connector notches fit into the
grooves of the jack only one-way.) Match the
wire colours to the polarity label in the battery
compartment, and push the connector in until
you hear a click.
2
3
Make sure you have a good connection by
slightly pulling on the battery wires. If the
connection is secure, the battery jack will remain
in place.
4
5
Place the battery case cover back on the
handset by sliding it upwards until it clicks into
place.
Place the handset in the charging cradle with
the keypad facing forward.
• Use only the Uniden battery (BT-446)
supplied with your phone.
Replacement batteries are also
available. Visit our web site at
• Recharge your handset on a regular
basis by returning the handset to the
charger after each phone call.
Rechargeable Nickel-Metal-Hydride
Batteries Must Be Recycled or
Disposed of Properly
(2)
Step 2: Connect the Charger
1
Connect the AC adaptor to
the DC IN 9V jack and to a
standard 240V AC wall outlet.
Set the charger on a desk or
tabletop, and place the
2
handset in the charger with the
keypad facing forward.
3
Make sure the charge LED
illuminates. If the LED does
not illuminate, check to see
that the AC adaptor is plugged
in and that the handset makes
good contact with the charger
charging contacts.
• Use only the supplied AAD-210AC adapter. Do not use any
other AC adapter.
• Place the charger close to the AC outlet so that you can unplug
the AC adaptor easily.
4
Charge the handset for 15-20 hours before using.
Step 3: Register the Handset
YOU NEED TO REGISTER THE DSS7805 TO THE MAIN BASE BEFORE USE!
1
Be sure the handset battery is
fully charged.
DSS7805
2
With the main base in standby
mode (i.e., not being used),
place the extra handset in the
main base unit to begin
DSS7805
registration.
3
While the handset is registering,
Handset Registering will
appear in the LCD. When
Registration Complete is
displayed, the handset has been
registered to the base. If
Registration Failed appears,
please try these steps again.
DSS7805
DSS7805
(3)
Using Your Expansion Handset
Now the your new handset is registered, it can perform all the same
functions as the handsets originally included with your phone. With your new
handset, you can
•
•
•
•
•
Transfer calls between handsets
Use two handsets as walkie-talkies in DirectLink mode
Use two handsets as a baby/room monitor
Hold 3- or 4- conference calls (depending on model)
Access your main base's integrated answering device (if available)
See the owner's manual that came with your main base unit for complete
instructions on operating your new expanded digital phone.
Battery Information
Low battery alert
When the batteries are very low and need to be charged, the phone is
programmed to eliminate functions in order to save power.
The batteries need to be charged when:
-
-
The empty battery icon appears.
Low Battery appears in the display.
If the phone is in standby mode, none of the keys will operate.
If you are on a call, complete your conversation as quickly as possible,
and return the handset to the charging cradle.
Cleaning the battery charging contacts
To maintain a good charge, it is
important to clean the charging
contacts on the handset once a
month. Using water only, dampen a
cloth to clean the charging contacts.
Then make sure to go back over the
charging contacts with a dry cloth
before returning the handset to the charger to charge.
Caution: Do not use paint thinner, benzene, alcohol, or other chemical
products. Doing so may discolour the surface of the telephone and
damage the finish.
(4)
(5)
Warranty
UNIDEN DSS7805 Cordless Phone
Limited One Year Warranty
Note: Please keep your sales docket as it provides evidence of warranty.
Warrantor: Uniden Australia Pty Limited ABN 58 001 865 498
Uniden New Zealand Limited
Warranty only available in original country of purchase
Elements of Warranty: Uniden warrants to the original retail owner for the duration of
this warranty, its DSS7805 Cordless Phone (hereinafter referred to as the Product) to
be free from defects in materials and craftsmanship with only the limitations or
exclusions set out below.
Warranty Duration: This warranty to the original retail owner only, shall terminate and
be of no further effect ONE (1) Year after the date of original retail sale. This warranty
will be deemed invalid if the product is; (A) Damaged or not maintained as reasonable
and necessary, (B) Modified, altered or used as part of any conversion kits,
subassemblies, or any configurations not sold by Uniden, (C) Improperly installed, (D)
Repaired by someone other than an authorized Uniden Repair Agent for a defect or
malfunction covered by this warranty, (E) Used in conjunction with any equipment or
parts or as part of a system not manufactured by Uniden, (F) Installed, programmed or
serviced by anyone other than an authorized Uniden Repair Agent, or (G) Where the
Serial Number label of the product has been removed or damaged beyond recognition.
Parts Covered: This warranty covers for 1 year, the Handset and Charge Unit only.
Accessories: Batteries, AC adaptor etc are covered for 90 days.
Statement of Remedy: In the event that the product does not conform to this warranty
at any time while this warranty is in effect, the warrantor at its discretion, will repair the
defect or replace the product and return it to you without charge for parts and service.
THIS WARRANTY DOES NOT COVER OR PROVIDE FOR THE REIMBURSEMENT
OR PAYMENT OF INCIDENTAL OR CONSEQUENTIAL DAMAGES. THIS
GUARANTEE IS IN ADDITION TO AND DOES NOT AFFECT YOUR RIGHTS UNDER
THE CONSUMER GUARANTEES ACT.
Procedure for obtaining performance or warranty: In the event that the Product
does not conform to this warranty, the Product should be shipped or delivered, freight
prepaid, with evidence of original purchase, (eg. a copy of the sales docket), to the
warrantor at:
UNIDEN AUSTRALIA PTY LTD
Service Division
UNIDEN NEW ZEALAND LTD
Service Division
345 Princes Highway,
Rockdale, NSW 2216
Fax (02) 9599 3278
150 Harris Road, East Tamaki,
Auckland
Fax (09) 274 4253
(6)
©2005 Uniden Australia Pty Limited, Uniden New Zealand Limited. Printed in China.
UUZZ01425BZ
|